GENERAL CAGE CLAMPS

Simple, quick and easy to set up for accurate alignment

Three closure styles to choose from

Tack or no Tack design

FEATURES

  • Hand Lever Clamp: 2″-60″
  • Hydraulic Clamp: 2″-60″
  • Ratchet Clamp: 6″-60″
  • Available with stainless steel contact points
  • Tack design features flat crossbars
  • No tack design features arched crossbars for full 360-degree welding

DOWNLOADS

General Cage Clamps Cutsheet

General Cage Clamps

General Tipton Cage Clamps provide accurate alignment on even the toughest jobs. It is easy to use and install. Hand lever, Ratchet, or Hydraulic style clamps will meet your demands. The tack design features flat cross bars and the no tack design features arched cross bars to allow 360 degree welding capabilities without removing the clamp. Both designs are available with stainless steel contact points.

Simple, quick and easy to setup for accurate alignment.

The Hand Lever Cage Clamp is simple, quick and easy to use! It has been an industry standard for over 50 years. This clamp ranges in sizes from 2″ to 60″.

The Hydraulic Cage Clamp is available in pipe sizes 16″ to 60″. The clamp pulls down tight with a hydraulic jack for effortless pipe alignment. The hydraulic closure mechanism on this cage clamp also enables rapid release after welding.

The Ratchet Cage Clamp’s Acme thread design delivers both strength and ease of operation. This clamp ranges in sizes from 6″ to 60″. A standard 1″ ratchet wrench fits all clamp sizes